Jumper R1F F.port Receiver Telemetry full duplex Support Jumper T8 T12 T16 Series Frsky D16 Radio


The Jumper R1F is a 16 Channel SBUS receiver with F-Port out which simplifies connecting a receiver to a flight controller. F-Port combines SBUS and Smartport telemetry in a single wire. Not only does this simplify a build, but it also saves a UART on the flight controller. Now the user can get all the telemetry data they desire, including RSSI, over the same wire their SBUS signal goes through.

Availability: In stock SKU: JUMP101 Category:



Channels: 16 Channels (SBUS)
RSSI Output: 0-3.3V
Telemetry: F.Port
Weight: <2g Dimensions: 20 x 125 x 4mm Operating Voltage: 4.0-6.0V Operating Current: 80mA@5V Effective Distance: Full Distance >1.5km
Compatibility: FrSky D16 mode

Press and hold the receiver’s bind button, turn on power. The green led will be on and the red led will flash indicating bind mode.
Turn on radio and enter bind procedure. After bind is successful the green led on the receiver will be off and the red led is always on.
Do not forget to power cycle the receiver and exit bind mode on radio
1x Jumper R1F Receiver

Additional information

Weight15 g
Dimensions12 × 8 × 1,5 cm


1 review for Jumper R1F F.port Receiver Telemetry full duplex Support Jumper T8 T12 T16 Series Frsky D16 Radio

  1. 3 out of 5

    David (verified owner)

    NOT droneit’s fault. I kind of knew you had to ”de-invert” signals on frsky receivers for f4 flight controllers. But since this is jumper and fport I thought it might work without inverting. But I was wrong. And the process is a bit tricky, you must do it on tje receiverr and two inverters need to be removed, the gaps bridged and a resistor needs to be added. The soldering is quite fiddly. I got it working but ripped of two non-crucial solder pads in the process. Then a last minute change ripped of another pad and now the whole thong is in the bin.

Only logged in customers who have purchased this product may leave a review.